Commands In The Interface Configuration Mode; Switchport Ingress-Filter - Siemens SCALANCE XM-400 Configuration Manual

Load control
10.2 Static MAC filtering
10.2.2

Commands in the interface configuration mode

This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
Global configuration mode.
● If you exit the Interface configuration mode with the
Privileged EXEC mode.
10.2.2.1

switchport ingress-filter

Description
With incoming packets, the ingress filter checks whether the port on which the packet was
received belongs to the sending VLAN. If this is not the case, the packet is not processed.
With this command, you enable the ingress filter.
Requirement
You are in the interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
switchport ingress-filter
Result
The ingress filter is activated.
Further notes
You disable the filter with the
You can display the status of the ingress filter and other settings with the
config
466
command.
interface
no switchport ingress-filter
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
command to change to this mode.
command, you return to the
exit
command, you return to the
end
command.
show vlan port