Scalance Sc632-2C Configuration; Setting Up Access To The Web Based Management Of The Scalance Sc632-2C - Siemens SCALANCE XC-200 Set Up And Configuration

5 Firewall configuration using the example of a SCALANCE SC632-2C
Note If the interfaces are interchanged, SCALANCE SC loses its protection function.
5.2

SCALANCE SC632-2C configuration

The SCALANCE SC632-2C is configured using Web Based Management (WBM).
Note The configuration of the firewall with the Security Configuration Tool (SCT) is not
supported by the SCLANCE SC family.
Requirement
To configure SCALANCE SC632-2C, it must be first reset to factory settings.
You can reset the SCALANCE SC632-2C to factory settings by pressing and
holding the reset button for about 5 seconds during device start-up until the Fault
"F" LED is constantly lit.
Furthermore, at least firmware version V2.0 is required.
Note The firmware can be downloaded from the following entry:
https://support.industry.siemens.com/cs/de/en/view/109764481
5.2.1 Setting up access to the Web Based Management of the SCALANCE
SC632-2C
To configure the SCALANCE SC632-2C, the first step is to establish the
connection to Web Based Management.
1. Assign the previously defined IP address "192.168.10.12" and subnet
mask "255.255.255.0" as described in chapter 3.2
2. Access the WBM and carry out the steps described in chapter 3.3
(changing the password, checking and updating the firmware version if
necessary).
Service Bridge – Setup and Configuration
Entry ID: 109747975, V1.4, 05/2019
52