Load control
10.1 Rate control
Result
The limitation of the outgoing data stream of the interface with the packet rate is enabled.
Further notes
You disable the function with the
10.1.2.2
no rate-limit output
Description
With this command, you disable the packet rate for limiting the outgoing data stream of the
interface.
Requirement
You are in the interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no rate-limit-output
Result
The limitation of the outgoing data stream of the interface with the packet rate is disabled.
Further notes
You enable the function with the
10.1.2.3
storm-control
Description
If several packets are sent to some or all nodes in a network at the same time, processing
bottlenecks may occur. To prevent this, the sending of these packets can be delayed until
the network load has fallen below a threshold.
This function is known as storm control.
With this command, you enable the storm control function for broadcast, multicast or
unknown unicast packets of an interface.
456
no rate-limit output
command.
rate-limit-output
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
command.