Layer 3 functions
9.4 RIPv2
The command prompt is as follows:
cli(config-if-vlan-$$$)#
or
cli(config-if-RPort-%%$$$)#
where %% is a short name for the interface type and $$$ is the numbering of the interface.
Syntax
Call up the command with the following parameters:
ip rip receive version (1 | 2 | 12 | none)
The parameters have the following meaning:
Parameter
1
2
12
none
Result
It has been specified which RIP version incoming updates need to have.
9.4.4.4
no ip rip receive version
Description
This command specifies that there is no restriction relating to the version of received RIP
updates. Updates according to RIPv1 and RIPv2 are received.
Requirement
You are in the VLAN configuration mode of the VLAN interface with the ID $$$ or in the
configuration mode for a router port.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
or
cli(config-if-RPort-%%$$$)#
where %% is a short name for the interface type and $$$ is the numbering of the interface.
428
Description
Only RIPv1 updates are received.
Only updates to RIPv2 are received.
Updates that correspond to RIPv1 or RIPv2 are
received.
No RIP updates are received.
Values
-
-
-
-
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07