Security and authentication
11.3 MAC access control list
11.3
MAC access control list
This section describes commands for working with MAC access control lists.
11.3.1
show access-lists
Description
This command shows the configuration of the access control lists (Access Control List).
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show access-lists [ [{ip | mac}] <access-list-number (1-128)> ]
The parameters have the following meaning:
Parameters
ip
mac
access-list-number
If you do not select any parameters from the parameter list, the configuration of all access
control lists will be displayed.
Result
The configuration of the access control lists is displayed.
486
or
cli#
Description
Selects IP-based access lists (IP ACL)
Selects MAC-based access lists (MAC
ACL)
Number of the access control list
Range of values
-
-
1 ... 128
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07