You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
switchport
Result
The interface is configured as a switch port. Activate the interface again.
Further notes
You shut down the interface with the
You activate the interface with the
You configure the interface with the
You can display the status of this function and other information with the
interface
3.1.11.13
no switchport
Description
With this command you configure the interface as a router port. This disables all switching
and layer 2 functions.
Requirement
● The Interface is shut down.
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no switchport
Result
The interface is configured as a router port.
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
command.
command.
shutdown
command.
no shutdown
command.
no switchport
Configuration
3.1 System
show ip
75