Layer 3 functions
9.3 OSPFv2
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
no ip ospf transmit-delay
Result
The interval is deleted.
Further notes
You configure the interval with the
9.3.14.17
ip ospf priority
Description
With this command, you specify the router priority. The designated router is identified based
on the priority.
Note
This command is available only with layer 3.
Requirement
● The interface is a layer 3 interface.
● You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if)#
Syntax
Call up the command with the following parameters:
ip ospf priority <value (0 - 255)>
The parameter has the following meaning:
Parameter
Value
412
ip ospf transmit-delay
Description
Priority
command.
Range of values / note
0 ... 255; Default: 100
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07