No Summary-Address; Commands In The Interface Configuration Mode - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.3 OSPFv2
9.3.13.27

no summary-address

Description
With this command, you delete the address range.
Note
This command is available only with layer 3.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
no summary-address <Network> <Mask> <AreaId>
The parameters have the following meaning:
Parameter
Network
Mask
AreaId
Result
The address range is deleted.
Further notes
You configure the address range with the
9.3.14

Commands in the Interface Configuration mode

This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
398
Description
IP address of the address range
Subnet mask of the address range
Area-ID
summary-address
interface
Range of values / note
specify the IP address
specify the subnet mask.
specify a valid ID.
x.x.x.x
x = 255
0.0.0.0 = backbone area
command.
command to change to this mode.
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07