Diagnostics
12.5 Loop detection
Syntax
Call the command without parameters:
loopd vlan mode
Result
The loop detection function is enabled for VLAN.
Further notes
You disable the function with the
You can display the status of this function and other information with the "show loopd"
command
12.5.3.4
no loopd vlan mode
Description
With this command, you disable the loop detection function for VLAN.
Requirement
● Loopd is activated
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no loopd vlan mode
Result
The loop detection function is disabled for VLAN.
Further notes
You enable the function with the
You can display the status of this function and other information with the "show loopd"
command
596
command.
no loopd vlan mode
command.
loopd vlan mode
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07