Siemens SCALANCE XM-400 Configuration Manual page 380

Layer 3 functions
9.3 OSPFv2
}]
The parameters have the following meaning:
Parameter
area-id
router-id
authentication
hello-interval
value
retransmit-interval
value
transmit-delay
value
dead-interval
value
authentication-key
key
message-digest-key
key-id
380
authentication-key <key (8)> | message-digest-key <Key-id (0-255)>
md5 <key(16)>
Description
Area ID
ID of the router. The router ID must
correspond to the IP address of the
interface of the transit area network.
Keyword for the authentication
method of the virtual connection
Keyword for the interval at which
Hello packets are sent over the virtual
link
specifies the length of the interval in
seconds.
Keyword for the interval after which
packets whose receipt was not
confirmed are transferred again.
specifies the length of the interval in
seconds.
Keyword for the time that a link state
update packet requires for
transmission over the virtual link.
Specifies the length of the interval in
seconds.
Keyword for the interval after which
the neighbor router is classified as
"failed" if Hello packets from it are not
received.
Specifies the length of the interval in
seconds.
Keyword for the unencrypted
password
Password
Keyword for the ID of the password
ID of the password.
Range of values / note
specify a valid ID.
x.x.x.x
x = 0 ... 255
0.0.0.0 = backbone area
-
•
simple
enables authentication using a
password
•
messagedigest
enables authentication using
MD5
•
none
no authentication
-
enter the interval
1-65535
-
enter the interval
0-3600
--
enter the interval
0-3600
-
enter the interval
0–0x7fffffff
-
enter the password.
Maximum length:
-
specify the ID
0 ... 255
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
characters
8