Port-Channel Load-Balance - Siemens SCALANCE XM-400 Configuration Manual

6.2.4.1

port-channel load-balance

Description
With this command, you configure the load balancing policy for the interconnected ports of
the previously defined port channels.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
port-channel load-balance
{mac-src-dst | ip-mac-src-dst}
[<port-channel-index(1-8)>]
The parameters have the following meaning:
Parameter
mac-src-dst
ip-mac-src-dst
port-channel-
index
If you do not enter a value for
Result
The load balancing policy is set.
Further notes
You can reset the setting for the load balancing policy to the default with the
load-balance
You can display the status of this function and other settings with the
command.
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Description
Load balancing is based on the MAC addresses of the sources
and destinations.
Load balancing is based on the IP and MAC addresses of the
sources and destinations.
Number of the port channel
port-channel-index
command.
, the setting is used for all port channels.
show etherchannel
Network structures
6.2 Link aggregation
Range of
values
-
Default:
enabled
-
1 ... 8
no port-channel
179