3.5
PoE
3.5.1
show poe status
Description
This command shows specific information for all or for a selected PoE interface (PoE: Power
over Ethernet).
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show poe status [interface <iftype> <ifnum>]
The parameters have the following meaning:
Parameter
iftype
ifnum
Note
Calling commands without parameters
If you use the command without setting parameters, information about all PoE interfaces is
displayed.
Result
The information is displayed.
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
or
cli#
Description
Type of interface
Slot no. and port no. of an interface
separated by a slash
Values
gigabitethernet
E.g. 1/2 for slot 1, port 2
Configuration
3.5 PoE
95