No Ip Dhcp Relay Circuit-Id - Siemens SCALANCE XM-400 Configuration Manual

ip dhcp relay circuit-id <circuit-id>
The parameter has the following meaning:
Parameters
Circuit ID
Result
The Circuit ID is assigned.
Further notes
You remove the Circuit ID with the
You configure the interface as a router port with the
You display the IP addresses with the
You display the settings with the
7.3.4.2

no ip dhcp relay circuit-id

Description
With this command, you remove the Circuit ID.
Requirement
● The interface is a router port.
You are in the Interface Configuration mode of VLAN
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
no ip dhcp relay circuit id
Result
The Circuit ID is removed.
Further notes
You configure the Circuit ID with the
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Description
Circuit ID
no ip dhcp relay circuit-id
show dhcp server
show ip dhcp relay information
ip dhcp relay circuit-id
Range of values
1 ... 188
command.
command.
no switchport
command.
command.
command.
Network protocols
7.3 DHCP Relay
265