Configuration
3.2 Load and Save
3.2.6
Commands in the LOADSAVE configuration mode
This section describes commands that you can call up in the LOADSAVE configuration
mode.
In the Global Configuration mode, enter the
You display the valid file types for the commands in the LOADSAVE Configuration mode
with the global command
● If you exit the LOADSAVE configuration mode with the
Global Configuration mode.
● If you exit the LOADSAVE configuration mode with the
Privileged EXEC mode.
3.2.6.1
delete
Description
With this command, you call up the possible files or delete a specific file.
Requirement
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
Syntax
Call up the command with the following parameters:
delete{showfiles|filetype<filetype>}
The parameters have the following meaning:
Parameter
showfiles
filetype
filetype
Result
The files are displayed or the file is deleted.
84
show loadsave tftp
Description
Shows the available files
Shows that the file type follows that will be deleted
Name of the file type
command to change to this mode.
loadsave
.
command, you return to the
exit
command, you return to the
end
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Values
-
-
max. 100 characters