For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 30)".
Result
The entry is deleted.
Further notes
You configure an entry from the IP routing table with the
You display the IP routing table with the
See also
Addresses and interface names (Page 30)
7.1.11.3
ip routing
Description
With this command, you enable the routing function.
Note
This command is available only with layer 3. DHCP must not be enabled on any IP interface.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
ip routing
Result
The routing function is enabled.
Further notes
You disable the function with the
You display the setting with the
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
show ip route
command.
no ip routing
command.
show ip route
Network protocols
7.1 IPv4 protocol
command.
ip route
command.
241