No Ip Ospf Message-Digest-Key - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.3 OSPFv2
Requirement
● The interface is a layer 3 interface.
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
ip ospf message-digest-key <Key-ID (0-255)> md5 <md5-Key (16)>
The parameters have the following meaning:
Parameter
Key-ID
md5
md5-Key
Result
The password and the ID are specified.
Further notes
You delete the password with the
9.3.14.12

no ip ospf message-digest-key

Description
With this command, you delete the required password.
Note
This command is available only with layer 3.
Requirement
● The interface is a layer 3 interface.
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
408
Description
ID of the password
Keyword for the password
Password for authentication
no ip ospf message-digest-key
Range of values / note
0 ... 255
-
enter a password
Maximum length: 16 characters
command.
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07