No Ip Access-Group - Siemens SCALANCE XM-400 Configuration Manual

Security and authentication
11.4 IP access control list
Note
Restrictions when filtering layer 2 interfaces
The filtering of outgoing packets is not supported on layer 2 interfaces
Filtering on a layer 2 interface using an IP access control list is only effective for IP packets.
To filter packets with other data formats, use an expanded MAC access control list.
Result
The packets are filtered according to the access control list (ACL).
Further notes
You disable the setting with the
You show the configuration of the access control list with the
11.4.2.2

no ip access-group

Description
With this command, you disable the access control of the packets of an interface.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
no ip access-group [<access-list-number(1-65535)>]{in|out}
The parameters have the following meaning:
Parameters
access-list-number
in
out
If you do not specify a number of for an access control list, all lists are deleted.
498
no ip access-group
Description
Number of the access control list
Specifies that incoming packets are filtered
Specifies that outgoing packets are filtered
command.
show access-lists
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
command.
Values
1 ... 65535
-
-