Vrrp Virtual-Ping - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Call up the command with the following parameters:

no interface{vlan <vlan-id(1-4094)

The parameters have the following meaning:

interface-type

interface-id

For information on names of addresses and interfaces, refer to the section "Addresses and

interface names (Page 30)".

The logical interface is deleted.

Further notes

You configure a VRRP interface with the

You display the status and the configuration of the VRRP interface with the

interface show vrrp interface - vrid

vrrp virtual-ping

With this command, you enable pings to virtual addresses.

● The Router Configuration mode is activated.

You are in the Router vrrp Configuration mode.

The command prompt is as follows:

cli(config-vrrp)#

Call the command without parameters:

vrrp virtual-ping

SCALANCE XM-400/XR-500 Command Line Interface

Configuration Manual, 05/2014, C79000-G8976-C252-07

<interface-type><interface-id>}

Keyword for a VLAN connection

Number of the addressed VLAN

Type or speed of the interface

Slot no. and port no. of the interface

Layer 3 functions

gigabitethernet

extreme-ethernet

Enter a valid interface name

Scalance xr-500