Ring-Redundancy Standby - Siemens SCALANCE XM-400 Configuration Manual

cli(config)#
Syntax
Call the command without parameters:
no ring-redundancy
Result
The ring redundancy function is disabled.
Further notes
You enable the ring redundancy function with the
mrpclient | hrpclient | hrpmanager }.
8.4.5.4

ring-redundancy standby

Description
With this command, you enable the standby function.
Requirement
● HRPis activated
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
ring-redundancy standby
Result
The standby function is enabled / disabled.
Further notes
You disable the setting with the
You can display the status of this function and other information with the
redundancy
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
no ring-redundancy standby
command.
Layer 2 management protocols
8.4 Ring redundancy and standby connection
ring-redundancy mode { ard | mrpauto |
command
command.
show ring-
337