7.5.4.1
smtp-server
Description
With this command, you configure an entry for an SMTP server.
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call up the command with the following parameters:
smtp-server {ipv4 <ucast_addr> | fqdn-name <FQDN(100)>} <receiver mail-address>
The parameters have the following meaning:
Parameter
ipv4
ucast_addr
fqdn-name
FQDN(100)
receiver mail-
address
For information on addresses and interfaces, refer to the section "Addresses and interface
names (Page 30)".
Result
An entry for the SMTP server is configured.
Further notes
You delete an SMTP server entry with the
7.5.4.2
no smtp-server
Description
With this command, you delete an SMTP server entry.
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Description
Keyword for an IP address
Value for an IPv4 unicast address Enter a valid IPv4 unicast address.
Keyword for a domain name
Domain name (Fully Qualified
Domain Name)
Name of the recipient
no smtp-server
Network protocols
7.5 SMTP client
Range of values
-
-
Maximum of 100 characters
max. 100 characters
command.
297