The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
dot1x guest-vlan
Result
The guest VLAN function is enabled for the device.
Further notes
You also need to enable the guest VLAN function for the device. You do this with the
guest-vlan
You disable the function with the
11.7.5.2
no dot1x guest-vlan
Description
With this command, you disable the guest VLAN function for a port.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no dot1x guest-vlan
Result
The guest VLAN function is disabled for the device.
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
command in the Global configuration mode.
no dot1x guest-vlan
Security and authentication
11.7 Port Based Network Access Control
command
dot1x
531