Security and authentication
11.3 MAC access control list
11.3.5.1
permit
Description
With this command, you configure a MAC address control list that describes the MAC
addresses for which incoming and/or outgoing data traffic is permitted.
The access control list contains only one entry. If you want to lock or permit further
addresses, create a new access control list.
Note
Processing order of the lists
The access control lists are processed on he interface in the order in which they were
created.
The index number of the access control list is not used for this.
Requirement
You are in the MAC ACL Configuration mode.
The command prompt is as follows:
cli(config-ext-macl)#
Syntax
Call up the command with the following parameters:
permit {any|host<src-mac-address>}{any|host<dest-mac-address>}
The parameters have the following meaning:
Parameter
any
host
src-mac-address
any
host
dest-mac-address
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 30)".
492
Description
Keyword for "all"
Keyword for the MAC address of an incoming
connection that is permitted
MAC address of the permitted incoming connection
Keyword for "all"
Keyword for the MAC address of an outgoing
connection that is permitted
MAC address of the permitted outgoing connection
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Values
-
-
Enter a valid MAC
address
-
-
Enter a valid MAC
address