Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no subnet-vlan
Result
The classification is disabled.
Further notes
You enable the setting with the
You can display the status of this function and other information with the
info
6.1.2.9
vlan
Description
With this command, you create a VLAN on the device and change to the VLAN configuration
mode.
In the provider backbone bridge mode, this command is used to create user, service and
backbone VLANs.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
vlan <vlan-id(1-4094)>
The parameter has the following meaning:
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
command.
command.
subnet-vlan
Network structures
6.1 VLAN
show vlan device
155