Show Ip Telnet; Show Dcp Server - Siemens SCALANCE XM-400 Configuration Manual

7.1.4

show ip telnet

Description
This command shows the admin status and the port number of the telnet server.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show ip telnet
Result
The admin status and the port number of the Telnet server are displayed.
7.1.5

show dcp server

Description
This command shows whether or not the DCP function is enabled on the device.
If the DCP function is enabled, the read and write permissions are displayed.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show dcp server
Result
The overview of the status of the DCP function and access rights is displayed.
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
or
cli#
or
cli#
Network protocols
7.1 IPv4 protocol
235