8.2.5.5
ip igmp snooping switch-ip
Description
With this command, you configure the IP address of the source for IGMP snooping.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip igmp snooping switch-ip<switch-ipaddr>
The parameter has the following meaning:
Parameters
switch-ipaddr
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 30)".
Result
The IP address is configured.
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Description
Address of the source
Layer 2 management protocols
8.2 IGMP snooping
Range of values
Enter a valid IP address
327