List Of Messages - Printronix P7000 Series Maintenance Manual

Chapter 3
Troubleshooting Display Messages

List Of Messages

Find the message in the Message List below and follow the suggested
procedure. After correcting an error, press the CLEAR key to clear the
message and place the printer in the offline state.
If an error is not cleared, the printer will try to print again but will display the
error message until the error is cleared.
Table 4. P7000 ASCII (Spool) Error Messages List
Displayed Message
06 HOST REQUEST
08 HOLD PRINT
TIMEOUT
8.5V POWER FAIL *
42
Explanation
Status message: in the CT
emulation, the host
computer or printer
controller requires attention.
Status message: in the CT
emulation, the printer was
offline more than 10 minutes
and the "Intervention
Required" parameter is set
to "Send to Host."
8.5 Volt Power Failed.
Internal power failure.
Solution
Not a printer problem.
Press ON LINE.
1. Cycle power. If the message
appears, do the power supply
operational check (page 264). If
the power supply fails the check,
replace it. If it passes the check,
go to the next step.
2. Power on the printer. If the
message appears, replace the
controller board. Record the
message and return it with the
defective board.
3. Power on the printer. If the
message appears, replace the
shuttle frame assembly.