Printronix P7000 Series Maintenance Manual page 469

6. Remove the two 10-32 x 5/32 inch buttonhead screws and washers
securing the vertical rails to the upper frame cross-member at the rear of
the cabinet. (Figure 75.)
7. Remove the two Torx T-10 screws securing the stacker base to the
cabinet floor. (Figure 75.)
8. Remove the two Torx T-10 screws that secure the rail bracket to the
cabinet floor. (Figure 75.)
Left Vertical Rail
Washer
Left Screw, 10-32
x 5/32 inch
Screw,
Torx T-10
(2 places)
Rail Bracket
Right Vertical Rail
Upper Frame
Cross-Member
Figure 75. Preparing the Stacker for Removal
Stacker Motor Check
Right Screw, 10-32 x 5/32 inch
Washer
Stacker Base
Screw,
Torx T-10
Screw,
Torx T-10
469