Printronix P7000 Series Maintenance Manual page 306

Chapter 5
Replacement Procedures
9. Slide the right ribbon guide assembly into the side plate and install the
two 7/32 inch screws and washers. (See Figure 51 on page 354, items 7,
8, and 9.)
10. Install the interlock switch bracket:
a. Slide the bracket, with the interlock switch assembly attached, onto
b. Install the Phillips #1 screw and washer securing the switch and
11. Install the black metal washer onto the left side of the platen shaft.
(See page 350, item 26.)
12. Apply bearing lubricant to the nylon bearings in the two spring links, slide
the spring links onto the platen shafts, and connect the springs to the
spring hooks in the side plates. (See page 350, items 16, 17, and 18.)
13. Apply bearing lubricant to the platen shafts on both sides, between the
ends of the platen and the platen adjust brackets.
306
Platen
Washers
Wear
Saddle
Mechanism
Base Platen
Seat
Figure 36. Positioning the Platen Adjust Brackets
the platen shaft and up against the right side plate.
bracket.
Platen Adjust
Bracket