Printronix P7000 Series Maintenance Manual page 479

17. Align the holes in the stacker base with the holes in the cabinet floor.
(Figure 85c and Figure 86)
18. Install finger tight the 10-32 x 5/32 inch buttonhead screw and washer
securing the left vertical rail to the upper frame cross-member. (Do not
install the right hand screw yet.) (Figure 86.)
19. Install and tighten the two Torx T-10 screws securing the stacker base to
the cabinet floor. (Figure 86.)
20. Install and tighten the two Torx T-10 screws that secure the rail bracket to
the cabinet floor. (Figure 86.)
Left Vertical Rail
Washer
Left Screw, 10-32
x 5/32 inch
Screw,
Torx T-10
(2 places)
Rail Bracket
Right Vertical Rail
Upper Frame
Cross-Member
Screw,
Torx T-10
Figure 86. Stacker Fasteners
Stacker Motor Check
Right Screw, 10-32 x 5/32 inch
Washer
Screw,
Torx T-10
Stacker Base
479