Printronix P7000 Series Maintenance Manual page 173

Table 5. P7000 H-Series (Spool) Error Messages List
Displayed Message
E34 TRACE CMPLT
See User Manual
E99 UNKNOWN INT
See User Manual
E Net Test Unavailable
ERROR: CPLD NOT
PROGRAMMED
ERROR: DC
PROGRAM NOT
VALID
ERROR: DRAM AT
ADDRESS
XXXXXXXX
Explanation
An illegal or unsupported
instruction was attempted in
the application program.
An illegal or unsupported
instruction was attempted in
the application program.
The ethernet PCBA did not
initialize correctly.
The Complex Programmable
Logic Device (CPLD) on the
controller board is not
programmed. The EC
cannot read the version bits
in the CPLD which tell the
EC which configuration
version is installed.
The printer cannot find the
data controller program or
the validation checksum is
corrupt.
The printer found a defective
memory location.
List Of Messages
Solution
1. Cycle Power. Run the print job. If
the message appears again,
access the exception menu and
record the displayed messages
(page 222).
2. Power off the printer. Provide this
fault message and the messages
you recorded from the exception
menu to your next higher support
facility.
1. Cycle Power. Run the print job. If
the message appears again,
access the exception menu and
record the displayed messages
(page 222).
2. Power off the printer. Provide this
fault message and the messages
you recorded from the exception
menu to your next higher support
facility.
Cycle power. Wait for "E Net Ready"
to display, then retry operation. If it
still fails, replace the ethernet PCBA.
Cycle power. If the message appears
again, replace the controller board.
Record the message and return it
with the defective board.
1. Download the program again
(page 247).
2. If the message appears, replace
the flash memory SIMM.
1. Replace the DRAM DIMM.
2. Power on the printer. If the
message appears, replace the
controller board. Record the
message and return it with the
defective board.
173