Printronix P7000 Series Maintenance Manual page 62

Chapter 3
Troubleshooting Display Messages
Table 4. P7000 ASCII (Spool) Error Messages List
Displayed Message
CLEAR PAPER JAM
(continued)
62
Explanation
10. Check the condition and tension
11. Check and adjust the platen gap.
12. Clean the paper motion detector
Solution
of the paper feed belt. Adjust the
paper feed belt. Replace the belt
if it is damaged.
with a cotton swab and alcohol.
At the control panel, set the paper
motion detector (PMD) fault
setting to DISABLE. Load paper.
Run a print test and observe how
the paper feeds. If the message
appears, replace the controller
board. Record the message and
return it with the defective board.
If the message does not appear,
replace the paper detector switch
assembly and set the paper
motion detector (PMD) to
ENABLE.