Printronix P7000 Series Maintenance Manual page 475

5. Connect the power stacker logic cable P103 to connector J117 on the
controller board. (Figure 82.)
6. Disconnect the power supply cable from connector J101 on the controller
board. (Figure 82.)
7. Connect power supply cable connector P101 to the stacker power cable,
then connect the stacker power cable to connector J101 on the controller
board. (Figure 82.)
8. Route the stacker power cable in front of the controller board and down
through the cutout under the card cage fan. (Figure 82.)
9. Route the stacker logic cable in front of the controller board and down
through the cutout under the card cage fan. (Figure 82.)
Stacker Power Cable
7
Cutout Beneath
Card Cage Fan
Stacker Logic
Cable
Connector J117
Figure 82. Power Stacker Connections on the PSA3 Controller Board
Power Supply Connector P101
Connector J101
Stacker Motor Check
Connector P103
475