Printronix P7000 Series Maintenance Manual page 181

Table 5. P7000 H-Series (Spool) Error Messages List
Displayed Message
NON VOLATILE
MEMORY FAILED
ON LINE
PLEASE WAIT...
RESET IN
PROGRESS
PRINTER UNDER
REMOTE CONTROL
REMOVE USED SPX
THEN PRESS ENTER
RESTORING BOOT
CODE
Explanation
Large emulations reduce the
amount of space available
for saving configurations,
which means that
sometimes fewer than 8
configurations can be saved.
If this message appears
when saving a configuration,
it means the printer is out of
memory. Previously saved
configurations will still be
available, but the one that
was "saved" when the
message appeared is not in
memory. If this message
appears at power-up, it
means the flash memory is
defective.
Printer state message:
printer is online and in
communication with host.
Status message: the printer
finished loading the program
into flash memory and is
automatically resetting itself.
Status message: The printer
is under the control of
PrintNet Enterprise (PNE)
remote management
software.
Status message: An SPX is
depleted because it has
successfully reprogrammed
the security key on the
controller board.
Normal download
initialization message.
List Of Messages
Solution
1. If the message appears at power-
up, replace the flash memory.
2. If the message appears while
saving a configuration, the printer
is out of memory and will not save
that or subsequent
configurations. (Previously saved
configurations are still okay.)
3. If the message appears after
replacing/increasing memory,
replace the controller board. (Do
NOT attempt to replace NVRAM.)
No action is required.
No action is required.
No action is required.
1. Remove the SPX from the Debug
Port.
2. Press the ENTER key. The
printer will reboot itself.
No action is required.
181