Printronix P7000 Series Maintenance Manual page 483

27. Install finger tight the 10-32 x 5/32 inch buttonhead screw and washer
securing the right vertical rail to the upper frame cross-member.
(Figure 86.)
28. Move the elevator assembly up and down on the vertical rails until it
travels smoothly with no binding.
29. Tighten the two 10-32 x 5/32 inch buttonhead screws securing the vertical
rails to the upper frame cross-member.
30. Pull the paper tray out until the holes in the rails permit access to the
M3x6 screws. Tighten the M3 screws securing the vertical rails to the
stacker base. Each rail is secured by two screws. (Figure 83.)
31. Move the elevator assembly up and down and make sure it travels
smoothly with no binding. If the elevator binds or catches anywhere along
its path of travel, slightly loosen the upper rail screws and repeat steps 28
and 29 until the elevator moves smoothly.
32. Bundle the stacker control panel cables in the wire saddles located under
the card cage. Tie wrap the cables so they do not catch in the stacker
mechanism as it moves up and down. Route the stacker rail and frame
cables so they move without snagging as the elevator assembly moves
up and down. (Figure 90.)
Stacker Motor Check
483