Printronix P7000 Series Maintenance Manual page 476

Appendix D
Installing The Power Stacker
10. Pull the paper tray out until the holes in the rails permit access to the M3
buttonhead screws. (Figure 83.)
11. Loosen one turn—do not remove—the M3 screws securing the vertical
rails to the stacker base. Each rail is secured by two screws. (Figure 83.)
476
Figure 83. The Lower Screws in the Vertical Rails
M3x6 Buttonhead Screw
(Two on each rail)
Access Hole in
Tray Rail