Control Panel Assembly; Cover Assembly, Top, Pedestal Models - Printronix P7000 Series Maintenance Manual

Control Panel Assembly

Removal
1. Prepare the printer for maintenance (page 520).
2. Open the printer cover.
3. Disconnect the RJ-11 connector P310 from J2 on the back of the control
panel. (See page 540, item 5.)
4. Remove the two screws securing the control panel assembly to the panel
bracket. (See page 540, items 1, 18, and 19.)
5. Remove the control panel assembly from the panel bracket.
(See page 540, items 1 and 18.)
Installation
1. Engage the slot on the bottom of the control panel on the bottom edge of
the panel bracket cutout. (See page 540, items 1 and 18.)
2. Align the holes on the top rear of the control panel with the holes in the
upper edge of the panel bracket, and install the two mounting screws.
3. Connect RJ-11 connector P310 to connector J2 on the rear of the control
panel. (See page 540, item 5.)
4. Return the printer to normal operation (page 520).

Cover Assembly, Top, Pedestal Models

Removal
1. Prepare the printer for maintenance (page 520).
2. Remove the control panel assembly (page 527).
3. Loosen (do not remove) the two #2 Phillips hold-down screws on the rear
of the printer. (See page 540, item 4.)
4. Remove the #2 Phillips screw in the lower left front corner of the top cover
and the screw just to the right of the control panel bracket. (See page 540,
item 2.)
5. Lift the top cover assembly off the printer base. (See page 540, item 15.)
Installation
1. Reverse step 3 through step 5 of the removal procedure.
2. Return the printer to normal operation (page 520).

Control Panel Assembly

527