Printronix P7000 Series Maintenance Manual page 154

Chapter 3
Troubleshooting Display Messages
Table 5. P7000 H-Series (Spool) Error Messages List
Displayed Message
731:UNDEFINED
INTERRUPT*
732:UNDEFINED
OPCODE*
733:DP FIFO
BUSY*
900:ERROR: xxxx
901:FLASH FULL
REBOOT/ADD FLASH
902:RAM FULL
REBOOT/ADD RAM
B00 STATUS: SDRAM
DETECTION 166MHZ
154
Explanation
Undefined Interrupt.
Firmware error on the
controller board.
Undefined Opcode.
Firmware error on the
controller board.
There is a timing problem in
the Engine Controller
firmware.
User defined default using
PNE.
The printer requires more
flash memory to run the
downloaded program.
The printer requires more
RAM.
Status message: the printer
has begun its boot-up
routines and is checking for
the presence of SDRAM.
Solution
1. Cycle power. Run the print job
again. If the message appears,
download the emulation software
again.
2. Cycle power. Run the print job
again. If the message appears,
replace the controller board.
Record the message and return it
with the defective board.
1. Cycle power. Run the print job
again. If the message appears,
download the emulation software
again (page 247).
2. Cycle power. Run the print job
again. If the message appears,
replace the controller board.
Record the message and return it
with the defective board.
1. Cycle Power. Run the print job
again. If the message appears,
download the emulation software
again (page 247).
2. Cycle power. Run the print job
again. If the message appears,
replace the flash memory.
3. Power on the printer. Run the
print job again. If the message
appears, replace the controller
board. Record the message and
return it with the defective board.
User defined.
Add flash memory or use a smaller
emulation program.
Add RAM or use a smaller emulation
program.
No action required.