Printronix P7000 Series Maintenance Manual page 298

Chapter 5
Replacement Procedures
b. V5 controller only: Position the SDRAM DIMM in socket J14 with the
4. Cabinet Models: Install the paper path (page 303).
Pedestal Models: Install the top cover assembly (page 281).
5. Download the emulation (page 247).
6. If an SPX came with the flash memory, reprogram the security key (page
253).
7. Return the printer to normal operation (page 231).
8. Using the configuration printout(s) you made in step 1 of the removal
procedure, reset and save the printer configuration(s). (Refer to the
User's Manual.)
Controller Board*
* The V5 controller is shown here. For the layout
of the V6 controller, refer to Appendix A.
Figure 33. Memory Modules and Security Key
298
component side upward. Press the DIMM gently into the socket until
the edge connectors are seated, then press the DIMM downward until
the side latches lock it in place. (NOTE: SDRAM is soldered on the
V6 controller board and cannot be removed.) (See Figure 33 below.)
V5
J9: Security Key
J11: 72-pin Flash Memory SIMM:
4 MB = P/N 204480-901
8 MB = P/N 204480-902
16MB = P/N 204480-903
32MB = P/N 204480-904
NOTE: J10 is used for flash memory on the
V6 controller board. J11 is removed from the
V6 controller board.)
SDRAM:
32 MB DIMM = P/N 204535-901
NOTE: On the V6 controller board
SDRAM is soldered to the board
and cannot be removed.
Notched End
on this side
Flash Memory: