Printronix P7000 Series Maintenance Manual page 47

Table 4. P7000 ASCII (Spool) Error Messages List
Displayed Message
32 PAPER JAM
TIMEOUT (continued)
Explanation
9. Inspect the tractors and tractor
10. Check the condition and tension
11. Check the platen gap. Adjust the
12. Clean the paper motion detector
List Of Messages
Solution
door springs for damage,
excessive wear, and equal door
closing tension. If either tractor is
worn, damaged, or exhibits
uneven door closing tension,
replace both tractor assemblies.
of the paper feed belt. Adjust the
paper feed belt. Replace the belt
if it is damaged.
platen gap if necessary.
with a cotton swab and alcohol.
At the control panel, set the paper
motion detector (PMD) fault
setting to DISABLE. Load paper.
Run a print test and observe how
the paper feeds. If the message
appears, replace the controller
board. Record the message and
return it with the defective board.
If the message does not appear,
replace the paper detector switch
assembly and set the paper
motion detector (PMD) to
ENABLE.
47