Printronix P7000 Series Maintenance Manual page 564

Appendix F
Form Design Checklist
________
Cut-To-Tie Ratio
____:____ (Typical ratio is 4:1, or 80% cut to 20% tie)
Thickness Buildup = ________ in. / cm
NOTE: A cut-to-tie ratio that causes a thickness buildup greater than 0.025
Perforation Intersections
________
Chaff Content
________
________
564
Staples should be placed in the margins so that they coincide
with areas of the form where printing will not occur
in. / 0.0635 cm, or that creates an evenness variation greater than
0.003 in. / 0.00762 cm, will result in an unreliable and unpredictable
form.
Horizontal-vertical perforations are tie points. Cut points at
such intersections are unacceptable.
Tractor holes are clear of chaff.
There is no loose chaff in the box the paper is packed in.