Printronix P7000 Series Maintenance Manual page 531

Installation
1. Install the sensor knob and paper out sensor.
2. Route the paper out sensor cable up along the left side of the printer.
(See Figure 119 on page 530.)
3. Connect coupling shroud connector P106 to the controller board and
install tie-wraps to secure the motor cable.
4. Route the tie wraps through the tie wrap holes and around the paper out
sensor cable.
NOTE: Be sure that the tie wrap loops around the cable, towards the back of
the printer as shown in Figure 119, detail B on page 530.
5. Install the screws and left cover plate.
6. Position the paper out sensor. (See page 513.)
7. Return the printer to normal operation (page 520).
Paper Out Sensor
531