Printronix P7000 Series Maintenance Manual page 142

Chapter 3
Troubleshooting Display Messages
Table 5. P7000 H-Series (Spool) Error Messages List
Displayed Message
619:PAPER FEED
DRIVER CIRCUIT*
620:POWER SUPPLY
VOLTAGE*
621:RIBBON DRIVER
CIRCUIT*
622:SHUTTLE
DRIVER CIRCUIT*
142
Explanation
Paper Feed Driver Circuit.
The paper feed driver circuit
on the controller board is
drawing too much current.
Power Supply Voltage. The
power supply has failed.
The ribbon driver circuit on
the controller board is
drawing too much current.
The shuttle driver circuit on
the controller board is
drawing too much current.
Solution
1. Cycle power. If the message
appears, replace the controller
board. Record the message and
return it with the defective board.
2. Power on the printer. If the
message appears, replace the
paper feed motor.
Replace power supply board.
1. Power down the printer. Remove
the paper path or top cover to
gain access to the card cage.
Make sure the shuttle data and
power cables are undamaged
and have good connections at the
shuttle and the controller board.
2. Power on the printer. If the
message appears, replace the
controller board. Record the
message and return it with the
defective board.
3. Power on the printer. If the
message appears, replace the
shuttle frame assembly.
1. Power down the printer. Remove
the paper path or top cover to
gain access to the card cage.
Make sure the shuttle data and
power cables are undamaged
and have good connections at the
shuttle and the controller board.
2. Power on the printer. If the
message appears, replace the
controller board. Record the
message and return it with the
defective board.
3. Power on the printer. If the
message appears, replace the
shuttle frame assembly.