Printronix P7000 Series Maintenance Manual page 146

Chapter 3
Troubleshooting Display Messages
Table 5. P7000 H-Series (Spool) Error Messages List
Displayed Message
706:PAPER BAD
TABLE*
707:PAPER BUSY
TOO LONG*
708:PAPER FIFO
OVERFLOW*
146
Explanation
Paper Bad Table. The paper
feed process on the
controller board has a
corrupted table.
Paper Busy Too Long.
Firmware error on the
controller board.
Paper First In First Out
Overflow. Firmware error on
the controller board.
Solution
1. Cycle power. Run the print job
again. If the message appears,
download the emulation software
again.
2. Cycle power. Run the print job
again. If the message appears,
replace the controller board.
Record the message and return it
with the defective board.
1. Cycle power. Run the print job
again. If the message appears,
download the emulation software
again (page 247).
2. Run the print job again. If the
message appears, power off the
printer. Remove the paper path or
pedestal top cover. Make sure
connectors P106 and P107 are
fully seated on the controller
board. Make sure the MPU cable,
the hammer bank logic cable, and
the hammer bank power cable
are undamaged and have good
connections. Replace as
necessary. (Refer to Appendix
A.)
3. Power on the printer. Run the
print job again. If the message
appears, replace the shuttle
frame assembly.
4. Power on the printer. Run the
print job again. If the message
appears, replace the controller
board. Record the message and
return it with the defective board.
1. Cycle power. Run the print job
again. If the message appears,
download the emulation software
again.
2. Power on the printer. Run the
print job again. If the message
appears, replace the controller
board. Record the message and
return it with the defective board.