Printronix P7000 Series Maintenance Manual page 53

Table 4. P7000 ASCII (Spool) Error Messages List
Displayed Message
B02 STATUS:
SDRAM PASSED
B10 ERROR:
NO DRAM DETECTED*
B11 ERROR:
RAM TEST FAILED*
B12 ERROR:
PROGRAM MISSING*
B13 ERROR:
NOT COMPATIBLE*
B19 ERROR:
DC RETURNED*
Explanation
Status message informing
the operator that the printer
finished testing SDRAM.
Boot-up routines did not
detect the presence of the
SDRAM DIMM.
SDRAM failed the boot
initialization test.
The printer does not see a
program in flash memory.
The printer is not compatible
with the downloaded
program.
This message indicates an
incorrectly assembled and
tested machine.
List Of Messages
Solution
No action required.
1. Cycle power. If the message
appears again, power down and
check that there is an SDRAM
DIMM installed on the controller
board. If not, install the SDRAM.
If so, reseat the SDRAM DIMM.
2. Power up the printer. If the
message appears, replace the
SDRAM DIMM.
3. Power up the printer. If the
message appears, replace the
controller board. Record the
message and return it with the
defective board.
1. Cycle power. If the message
appears again, reseat the
SDRAM DIMM.
2. Power up the printer. If the
message appears, replace the
SDRAM DIMM.
3. Power up the printer. If the
message appears, replace the
controller board. Record the
message and return it with the
defective board.
There is no program in printer
memory. Download an emulation.
Load the correct emulation software
option(s) for this printer.
Cycle power. If the message appears
again contact the printer
manufacturer and report this
message.
53