Printronix P7000 Series Maintenance Manual page 162

Chapter 3
Troubleshooting Display Messages
Table 5. P7000 H-Series (Spool) Error Messages List
Displayed Message
D55 Status: Send
Program to EC
DIAGNOSTIC
PASSED
DO NOT POWER OFF
E00 EXE @ ADDR0
See User Manual
E01A TYPE 0x40
See User Manual
E01B TYPE 0x60
See User Manual
162
Explanation
Status message: The printer
is loading the engine
controller program into the
engine controller (EC).
Status message: the printer
passed its memory and
hardware initialization tests.
Status message: The printer
is performing an operation
that must be completed
before you can cycle power.
An illegal or unsupported
instruction was attempted in
the application program.
An illegal or unsupported
instruction was attempted in
the application program.
An illegal or unsupported
instruction was attempted in
the application program.
Solution
No action is required.
No action is required.
No action is required, but do not
power off the printer until the
operation is complete.
1. Cycle Power. Run the print job. If
the message appears again,
access the exception menu and
record the displayed messages
(page 222).
2. Power off the printer. Provide this
fault message and the messages
you recorded from the exception
menu to your next higher support
facility.
1. Cycle Power. Run the print job. If
the message appears again,
access the exception menu and
record the displayed messages
(page 222).
2. Power off the printer. Provide this
fault message and the messages
you recorded from the exception
menu to your next higher support
facility.
1. Cycle Power. Run the print job. If
the message appears again,
access the exception menu and
record the displayed messages
(page 222).
2. Power off the printer. Provide this
fault message and the messages
you recorded from the exception
menu to your next higher support
facility.