Printronix P7000 Series Maintenance Manual page 110

Chapter 3
Troubleshooting Display Messages
Table 4. P7000 ASCII (Spool) Error Messages List
Displayed Message
STACKER FULL
110
Explanation
Status message: the power
paper stacker is full.
Solution
1. Unload the stacker.
2. Check the stacker limit switches.
(See page 196.) If the limit
switches are OK, go to the next
step.
3. Power off the printer. Remove the
paper path. Disconnect stacker
cables from the controller board,
stacker assembly, and the
stacker control panel (see
Figure 79, page 472). Check
cables for cuts, breaks, or
damaged pins. Check continuity
of cables. (See Appendix A.)
Replace any cable that is
damaged or fails continuity test.