Ipv6 Neighbor Binding Lifetime - Cisco 300 Series Cli Manual

25
545
Example
In the following example, the Neighbor Binding policy policy1 is attached to VLAN
100:
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#

25.44 ipv6 neighbor binding lifetime

To globally change the default of the Neighbor Binding table entry lifetime, use the
ipv6 neighbor binding lifetime command in Global Configuration mode. To return to
the default setting, use the no form of this command.
Syntax
ipv6 neighbor binding lifetime
no ipv6 neighbor binding lifetime
Parameters
•
value
—The lifetime in minutes. The range is from 1 through 60 minutes.
Default Configuration
5 minutes
Command Mode
Global Configuration mode
User Guidelines
Use the ipv6 neighbor binding lifetime command to change the default lifetime.
Example
The following example changes the lifetime for binding entries to 10 minutes:
switchxxxxxx(config)#
interface vlan 100
ipv6 neighbor binding attach-policy policy1
exit
value
ipv6 neighbor binding lifetime 10
OL-32830-01 Command Line Interface Reference Guide
IPv6 First Hop Security