Enabling Cfs To Distribute Ivr Configurations - Cisco Nexus 5600 Series Configuration Manual

Enabling CFS to Distribute IVR Configurations

Procedure
Step 1
Step 2
Step 3
Step 4
This example shows how to enable CFS to distribute FC timer configurations:
switch(config)# fctimer distribute
switch(config)# show fctimer status
Distribution : Enabled
switch(config)# copy running-config startup-config
[########################################] 100%
Enabling CFS to Distribute IVR Configurations
You can enable CFS to distribute inter-VSAN routing (IVR) configurations in order to enable efficient IVR
configuration management and to provide a single point of configuration for the entire fabric in the VSAN.
Before You Begin
Make sure that you are in the storage VDC. To change to the storage VDC, use the switchto vdc fcoe command.
Make sure that you install the Advanced SAN Services license.
Make sure that you enable the IVR feature. To do so, use the feature ivr command.
Procedure
Step 1
Step 2
Step 3
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
54
Command or Action
switch# configure terminal
switch(config)# fctimer distribute
switch(config)# show application-name
status
switch(config)# copy running-config
startup config
Command or Action
switch# configure terminal
switch(config)# ivr distribute
switch(config)# show cfs application
Purpose
Enters global configuration mode.
Enables CFS to distribute FC timer configuration
updates.
(Optional)
For the specified application, displays the CFS
distribution status.
(Optional)
Saves the change persistently through reboots and
restarts by copying the running configuration to the
startup configuration.
Purpose
Enters global configuration mode.
Enables CFS to distribute IVR configuration updates.
You must enable IVR distribution on all
Note
IVR-enabled switches in the fabric.
(Optional)
Displays the CFS distribution status.
Using Cisco Fabric Services
OL-31641-01