ABB AC500-S Safety User Manual page 385

DiagCode State Name
8002 Safe
8003 Lock
8010 Output Disable Process control is not active.
8000 Output Enable Process control is active and safety is enabled.
4.6.6.18 SF_EDM
Standards Requirements
IEC 60204-1, Ed. Section 9.2.2: Stop function categories; Category 0
5.0: 2003
EN 954-1: 1996 5.2: Stop function; stop initiated by protective devices shall put the machine in a safe
state
6.2: Specification of categories: Fault detection (of the actuator, e.g. open circuits)
ISO 12100-2: 4.11.4: Restart following power failure/spontaneous restart
2003
EN 954-1: 1996 5.4 Manual reset
30.03.2017
State Description and Output Setting
Triggered safety function.
Ready = TRUE
S_OutControl = FALSE
Error = FALSE
Safety function startup inhibit is active. Reset required.
Ready = TRUE
S_OutControl = FALSE
Error = FALSE
Ready = TRUE
S_OutControl = FALSE
Error = FALSE
Ready = TRUE
S_OutControl = TRUE
Error = FALSE
AC500-S
Configuration and programming
AC500-S Libraries > SafetyBlocks_PLCopen_AC500_v22.lib
385