ABB AC500-S Safety User Manual page 202

Configuration and programming
System configuration and programming > Programming of AC500-S Safety CPU
DANGER!
The results of "delappl" , "setpwd" and "delpwd" command execution shall be checked by the
end-user through a log-on with CoDeSys Safety after powering off/on of SM560-S Safety CPU.
The following PLC Browser commands (these commands can be called from CoDeSys V2.3) from
PM5xx are related to SM560-S Safety CPU:
sdappl - It saves the boot project of Non-Safety CPU and the configuration data of all attached
communication modules as well as Safety CPU to SD card. The user data, SM560-S
online password and power dip value of the Safety CPU are not saved. To update Non-
safety CPU content with previously saved data using sdappl, one has to do appropriate
modifications in sdcard.ini file (mode = ..., etc.) on SD card,
tion and SD card handling for more details.
sdclone - It saves the boot project of Non-Safety CPU and the configuration data of all attached
communication modules including SM560-S Safety CPU to SD card. The user data, boot
project, SM560-S online password, power dip value and user data of the Safety CPU are
also saved on the SD card. After successful sdclone command execution, the "sdcard.ini"
file on SD card is automatically updated so that when SD card is inserted to the other
AC500 PLC with Safety CPU, the content of SD card is copied to that system to create a
so-called "clone" of the previous system.
sdcou- - The communication module firmware (e.g., SM560-S Safety CPU firmware) will be copied
pler <x> from SD card to the communication module at slot <x> and the firmware update will be
executed.
NOTICE!
The following PLC Browser commands from Non-safety CPU PM5xx can influence SM560-S
state:
reboot
It reboots Non-safety CPU and, as a result, SM560-S will be restarted as well.
resetprgorg
It restores PM5xx and SM560-S Safety CPU original state (all variables, Flash memory sections,
etc. get original values). SM560-S changes its state from RUN to SAFE STOP.
startprg, stopprg, resetprg and resetprgcold lead to the transition of SM560-S Safety
CPU to DEBUG RUN or DEBUG STOP states respectively.
202 AC500-S
Ä AC500 User Documenta-
30.03.2017